Published by The Maritime Executive

Published by The Maritime Executive

Published by The Maritime Executive

Published Jan 2, 2022 5:00 PM by The Maritime Executive

Is there an easy way to prevent corrosion inside void spaces of idle equipment or permanent structures? This is a major need, primarily in the oil and gas industry but also in any industry that deals with metal tanks, piping, boilers, heat exchangers, hollow metal structures, or even hard-to-reach areas between the layers of metal coils. Fortunately, Cortec® has developed VpCI®-337, a time-tested alternative to nitrogen blanketing for easy, effective corrosion protection of void spaces.

The Challenges of Nitrogen Purge

Nitrogen purge or nitrogen blanketing is commonly used to protect metal void spaces from corrosion by replacing the oxygen with nitrogen gas. However, there are three challenges to the success and efficiency of this method. First of all, nitrogen gas is expensive, raising a cost barrier especially where large spaces are concerned. The second challenge is that nitrogen requires constant pressure with an airtight seal. This necessitates regular monitoring and complete reapplication if a leak does occur. Third, leaks also pose a safety hazard for personnel who unknowingly enter an area where the deadly gas has settled and may be overcome in moments.

The Advantages of VpCI®-337

By contrast, VpCI®-337 is much safer, cost-effective, and easy to apply and maintain. VpCI®-337 is a waterborne Vapor phase Corrosion Inhibitor that can be applied by fogging into metal void spaces. This labor-saving technique uses a minimum of product to protect large areas or volumes. Vapor phase Corrosion Inhibitors in the fogging fluid diffuse throughout the void and are attracted to metal surfaces where they “condense” and form a protective molecular layer. This layer inhibits the corrosion reaction on the metal surfaces even in the presence of oxygen and residual moisture. The space must be completely closed for the corrosion inhibitors to be effective, but an air-tight seal is not required as for nitrogen purge. At the end of the preservation period, there is usually no need to remove the VpCI® layer—although this is easily done if needed.

VpCI®-337 Scope of Use

Another advantage of VpCI®-337 is its versatility. VpCI®-337 can provide corrosion protection for everything from massive heat recovery steam generators to small crates of metal parts. The following are real-life examples of how VpCI®-337 has been used:

Internal preservation of pig receivers enroute from construction yard to offshore installation site One-year protection of aboveground storage tank (AST) internals at a sulfur recovery plant Preservation of spare heat-exchanger tube bundles (in conjunction with VpCI®-132 and MilCorr® VpCI® Shrink Film) previously stored in nitrogen-pressurized canisters Temporary protection of fuel tanks in retired aircraft stored outdoors during museum renovation Transit protection of automotive frames shipped inside sea containers (VpCI®-337 fogged inside VpCI®-126 Film covered skids) Protective packaging element used for shipment of horizontally-opposed piston aircraft engines

VpCI®-337 is also an excellent option for manufacturer edge treatment of coils, fogging of oil drilling risers, internal protection of metal tubular structures, and much more.

The products and services herein described in this press release are not endorsed by The Maritime Executive.

Published Aug 13, 2022 3:10 AM by Zephyr Group

Through the acquisition of SKV, Zephyr has brought together two of the world’s top independent engine parts distributors in the same group, creating a world-class parts and service resource under one roof. The combination marks a natural evolution for two of the most established names in marine engine parts and service, and it creates synergies that will benefit customers worldwide.  Together as Zephyr Group, Zephyr and SKV stock the largest range of OEM (original equipment manufacturer)...

Published Aug 12, 2022 10:34 PM by The Maritime Executive

The devastating fire at the Matanzas fuel oil terminal in Cuba is out, but the damage is far from over. The blaze took out four of the site's eight large storage tanks, impeding marine terminal operations and forcing tankers to divert to smaller ports. The fire broke out last Friday night when lightning struck the facility, igniting one tank. A fierce, towering blaze spread gradually down the line for the next three days, igniting four tanks in one section. 130...

Published Aug 12, 2022 9:39 PM by The Maritime Executive

On Friday, the U.S. House of Representatives passed a package of climate, energy and health care funding proposals, drawn in large part from the Biden administration's defeated "Build Back Better Act" budget reconciliation bill. Though much slimmed down from the original multi-trillion-dollar plan, the rebranded Inflation Reduction Act of 2022 (IRA) will have sweeping effects on the development of the clean-power industry in the U.S. - including the offshore wind industry. President Biden is expected to sign the Act into...

Published Aug 12, 2022 8:44 PM by The Maritime Executive

In a rare instance of cooperation, Pakistan reports that its Navy responded to a distress call and helped in the rescue of Indian sailors after their 145-foot commercial sailing vessel capsized. The Jamna Sagar was reportedly in the Arabian sea near Gwadar along the western border with Iran and at the entrance to the Gulf of Oman. The distress call was received on August 9 and a Pakistan Navy ship along with two helicopters were dispatched to the area to...

© Copyright 2022 The Maritime Executive, LLC. All rights reserved.